Honeywell burner controller 7800 fault codes

KDM is also used to program the Valve. If the system fails to perform properly, note the fault code , fault message,. Close the master switch and start the system with a call for heat by raising the setpoint of the operating controller , see the relay module sequence.

Sequence time at the time of the fault. Flame failure response time. REMOVE ONLY FOR TERMINAL TEST ACCESS. Hours of operation at time of.

These codes help the service technician identify problems that occur with the relay or the components that are wired to the relay. On-Off status of all digital inputs and outputs. LED blinks a fault code ). Built-in features set up. To prevent possible hazardous burner operation, verify safety requirements each time a control is installed on a burner.

Can cause severe injury, . Example of pilot electrode set up. One possible boiler problem. If a display is use fault codes or 1will appear. Its a fault code on burner. Integrated Burner Control.

Add the optional keyboard display module, available in several languages, to provide current operating status, systems diagnostics and historical information. More than 1different fault codes with written descriptions let you quickly. Mounting dimensions of relay module and wiring subbase in in. Please do not rate me until we have had a chance to work through a solution. Do not use the ratings to rate the site, just the technician you are working with.

For site issues, contact customer service. Current alarm fault code and description. Selectable Recycle or Lockout via JR(during burner run only). Burner Controller checks for overpressure (over existing Boiler PSI) in the boiler by Checking the High Pressure Limit sensor.

Hold and Fault Message Summary. Relay Modules, so all listed steps may not apply to the unit installed. After about months I experienced the first of many, about twelve, code or 1 flame detected diagnostics. Use your scanner and check the previous fault codes to see if they occur around the same run hours or cycles.

There are a number of standards and codes for burners and . Honeywell feels obligated to inform you of the difference between.